Guides to roof structures, roof coverings and solar panels
The roof is the hardest part of a house to calculate, because sloping planes, hips and valleys do not show on the floor plan. This category contains tips and instructions on how to calculate roof pitch, why the true roof area is larger than the plan area and how roof tiles or metal sheets, battens, counter battens and membrane with overlaps are worked out from it. A tip on hip roofs shows the full calculation for a typical house.
If a solar PV system goes on the roof, the solar calculator lays out panels on each roof plane with edge distances and obstacles and estimates the output in kWp and the annual yield. Short tips warn about the minimum pitch for the chosen covering, a breathable membrane and shading on the panels. Common site mistakes, such as taking the area from the plan or leaving out counter battens, are described together with how to avoid them. The instructions explain the steps in the roof calculator and how to enter a roof plane for the panels. Open the roof calculator to get the area, rafters, covering and a full material list, ready to save as a PDF.
Open the calculator: Roof calculator
Other calculators in this category: Solar PV system
Tips
- Hip roof: tiles, battens, membrane and gutters – How many roof tiles, ridge tiles, battens, rolls of membrane and gutters a hip roof needs – example of a 12 × 9 m house with a 30° pitch.
Quick tips for your calculation
- Decide the roof pitch before choosing the covering: every tile and sheet has a minimum pitch stated by its manufacturer.
- Lay the breathable roof membrane with overlaps and counter battens, so water that gets under the covering can drain to the eaves.
- Shade from a chimney or tree on just a few panels can cut the output of the whole string, so place panels out of the shade.
Common mistakes
- Covering below its minimum pitch – Check the minimum pitch of the chosen covering before ordering.
- Membrane without counter battens – Fix counter battens over the membrane, then the tiling battens.
- Roof area taken from the floor plan – Calculate area along the slope, with overhangs and overlaps.
- Panels in partial shade – Place panels away from the shade of chimneys, trees and nearby buildings.
- One measurement per wall – Measure at two heights and check the diagonals.
How to use the calculator
- 1. Choose the roof shape (ridge, hips and valleys are created automatically).
2. Enter wall dimensions, pitch and overhangs.
3. Add roof windows, dormers and chimneys.
4. Set rafters, covering, membrane and gutters.
5. Check the plan, section and materials list, then download the PDF. - A sloping plane is longer than its projection: roof area = plan area ÷ cos(pitch). At 30° the roof is about 15 % larger than the plan, at 45° about 41 %.
- 1. Enter the location and choose PVGIS or manual yield
2. Enter the panel dimensions and power
3. For each plane enter dimensions, pitch, orientation, edge distances and obstacles
4. Check the layout on the drawing
5. Fetch production from PVGIS
6. For self-consumption enter annual consumption and choose a profile - The length along the eaves is the actual dimension. Enter the depth as the length along the slope or as the plan depth – the calculator converts it using the pitch. Orientation is the direction the plane faces: 180° is south.
All guide categories · Frequently asked questions about the calculators