Drywall guides: ceilings, partitions and wall linings

Drywall lets you build a suspended ceiling, a partition wall or a lining over an existing wall quickly, without wet trades and long drying times. This category contains guides on materials for plasterboard systems: how many boards you need per square metre, how many metres of CD and UD profiles go into a ceiling and how many CW and UW studs into a partition, and how many screws, tapes and joint compound to buy. A tip on partition walls shows the full calculation for a typical room.

The page explains the spacing of profiles and hangers, moisture-resistant boards for bathrooms and around showers, and why partition boards are counted for both sides. The step-by-step section covers measuring, fixing the profiles, mounting the boards, filling the joints and skim coating. You will also find common mistakes, such as working without checking the measurements or using standard boards in a wet zone, and instructions for choosing the mode in the calculator and how reserve and packs are calculated. The drywall calculator then gives a complete shopping list.

Open the calculator: Drywall calculator

Guides

  • Drywall materials: boards, profiles and screws per m² – Short answer: boards = area ÷ area of one board × (1 + allowance), rounded up; profiles, screws, tapes and joint compound are calculated from consumption rates per m². For a 50 m² ceiling with 1200 mm wide boards and a 10 % allowance that is 23 boards, 55 CD profiles of 3 m and 850 screws. Here is how ceilings and partition walls are calculated, with examples from the drywall calculator.

Tips

Step by step: Drywall calculator

  1. Mark the position of the wall or ceiling on the floor and ceiling.
  2. Fix the track (UW/UD) and set the studs (CW) at the required spacing.
  3. Fix the first layer of boards with staggered joints.
  4. Fit insulation and board the other side.
  5. Finish the joints with tape and jointing compound.
  6. Sand, remove dust and prepare the surface for painting.

Quick tips for your calculation

  • Stud spacing for plasterboard is usually about 60 cm; under tiles or heavier finishes reduce the spacing as the system instructions say. Learn more
  • In bathrooms use moisture-resistant boards and apply waterproofing on them in the shower zone before tiling. Learn more

Common mistakes

All common building mistakes

How to use the calculator

  • The calculator has four modes:

    • Ceiling – suspended ceiling with CD/UD profiles
    • Partition wall – CW/UW studs, boarded on both sides
    • Wall lining – lining of an existing wall (CW/UW or CD/UD)
    • Plastering – only finishing compound over the surface

    Pick the mode first, then enter the area.
  • The default reserve is 10 % and applies to boards, profiles, wool and, in Plastering mode, the finishing compound. Results are rounded up to whole packages (boards by the piece, profiles in 3 m lengths, screws in boxes, compound in buckets).

    Example: 20 m² ceiling → 20 ÷ 2.4 × 1.1 = 9.2 → 10 boards.

All guide categories · Frequently asked questions about the calculators